A factory reset will erase your lamp’s Wi-Fi settings and remove it from any groups or circles it was in. This is helpful if you’re switching networks, gifting the lamp, or starting over fresh.

Factory Reset Instructions

For most lamps:

1. Unplug and plug it back in four times quickly.
    

2. After the fourth plug-in, the lamp will turn solid orange for about 30 seconds.

3. During this time, tap and hold the top of the lamp three times—firm, deliberate presses.

4. The lamp will flash rainbow colors, then begin blinking lime green/yellow when it's ready for setup.

🔸 For lamps with firmware version 1.9.1 or earlier:

1. Unplug and plug it back in four times quickly.
    

2. After the fourth time, your lamp will show a slow rainbow, then begin flashing lime green/yellow.

3. Once it flashes green, you’re ready to reconnect the lamp using the app or Filimin Manager.

What’s next?

Once your lamp is blinking lime green/yellow, follow the normal setup steps in the Friendship Lamp App Setup: Your Step-by-Step Guide

If you need help, don’t worry—we’re here for you! Just reach out.